Seicor M90 Fiber Fusion Splicer / Cleaver

Description

Selling as is. Listing is "For parts or not working" because we do not have experience, training or a manual on how to operate this unit. Basic testing was done, but not under optimal conditions. This unit has lots of potential, but needs an experienced operator willing to spend some time to dial it in.
Here is what we can tell you about it:
We were able to make a couple of fusion splices with it. They had good tensile strength, and acceptable loss.
Left micrometer has a sticky spot that does not affect operation, but can be felt while operating. Right micrometer feels silky smooth.
X axis camera could use realigning, but is functional.*
X axis camera occasionally goes dark, but will come back after lightly tapping the unit.
Both x and y alignment motors work, however we were unable to get the auto alignment to find a solution.*
*Note: We were using 125u fiber in the 250u sleds, this likely contributed to the above issues.
Comes with  3x 250 sleds and 1x 125/900 sled.
Installed electrodes appear to have little wear, 2 more electrodes are in the tool pouch and appear new.
Foam parts are deteriorating.
Tool pouch has a number of tools, see photos.
Cleaver is operational.
Heater cord connector is loose, heater still works. Needs a new connector (or could probably be repaired using some epoxy)
DC input not tested. Onboard battery is old and probably wont take a charge. The charging LED comes on when powered up, but we did not give it much time to charge.
Case has lots of wear and tear, and had shipping labels directly attached.